So how do I load an earlier save so that I can complete this level, the only option I get is to 'continue' and that is no good to me. If the tractor spins too much, lower the draft control so the mulboards lift out of the ground quicker. I tried restarting the game a few times but the lift wont come back up because it is stuck in the slime and there is no way down other than to be on that lift. I don’t know squat about draft other than I still have my draft-card from 1966. Readjust the draft control lever or knob, as necessary. Lowering the Draft Lever only an inch will lower the implement completely, so perhaps it’s all working. Placing the Position Lever UP with the Draft Lever UP, then lowering the Position Lever. until I lowered the position-lever and then found it would (very stiffly) allow me to raise the Draft Lever. of the outlet again has to be proportioned so as to give all the draft required. Just for drill I decided to move the Draft Lever to exercise it and found it frozen (I imagined initially from lack-of-use.).īut your post SDT makes sense so I started it up and found it still frozen. action necessary when the piston moves up and down in the cylinder and. I keep a finish mower on it mostly and when I park it after mowing the runway I lower the implement and shut down the tractor, then raise the position-lever so that when I start it up again I don’t forget to raise the mower before backing out. Your shop/service manual will detail how to pull and service the unloader valve. You will have to pull the lift cover to get to it. I would think that your lift is out of adjustment and your Position Control follower pin worn. The most likely culprit, however, is a stuck unloader valve. Since I’ve got quarantine-boredom I decided to experiment with it and discovered it apparently frozen while just sitting in the shed. Draft control causes strange hydraulic performance occasionally (the rod attached to the top link may be stuck). I didn’t force it but I did apply about 5 lbs force and it didn’t move so I got curious. I have little use for Draft Control, but I do want my tractor to work properly and got curious about it after reading another thread. Not knowing squat about real farming (other than from the consuming end and that farmers are the real heros these days).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |